CommScope Era, Руководство по установке

Страница: 58 / 71

CommScope Era
™
Fiber Low Power Carrier Access Point Installation Guide M0201ANC_uc
Page 54 © June 2019 CommScope, Inc.
Mount the Fiber CAP L
Ceiling Mount a CAP L
You can mount a CAP L above or below a ceiling. When installing a CAP L below a ceiling, the use of the
optional Fan Kit determines how the CAP L can be ceiling mounted, as described in the following sections.
•
"Ceiling Mount a CAP L without a Fan Kit” on page 54
•
"Ceiling Mount a CAP L with a Fan Kit” on page 54 .
If you mount the CAP L above the ceiling, its antennas must protrude below the ceiling.
Ceiling Mount a CAP L without a Fan Kit
A CAP L that does not have a Fan Kit should only be installed above a suspended ceiling on a flat surface, using
the steps in
"Flat-Surface Mount a CAP L” on page 27 .
Ceiling Mount a CAP L with a Fan Kit
1
Follow the steps in "Unpack and Inspect the CAP L and Optional Accessories” on page 23 .
2
Refer to and observe all cautions listed in "General Mounting Cautions” on page 24 .
3
Refer to "Determine the CAP L Installation Site” on page 17 to determine the mounting location, which
must be able to support the weight and dimensions of the CAP L.
4
Follow the steps in one of the following sections that apply to securing the desired mounting bracket to
the CAP L:
•
"Wall Mount a CAP L Using a Flat Mounting Bracket Kit” on page 30
•
"Mounting a CAP L with an AC/DC Power Supply Kit” on page 38
•
"Mounting a CAP L with a Hybrid Fiber Splice Box Kit” on page 43
5
Use four 5/16-inch or M8 lag screws (or whatever screw type is appropriate for the material to which the
CAP L is to be mounted on) to mount the CAP L to the ceiling.
6
Follow the steps in "Ground the Fiber CAP L (Optional)” on page 55 if grounding is required or preferred.
7
Follow the steps in "Connect the Passive RF Antenna” on page 59 .