CommScope Era, Руководство по установке

Страница: 57 / 71

M0201ANC_uc CommScope Era
™
Fiber Low Power Carrier Access Point Installation Guide
© June 2019 CommScope, Inc. Page 53
Mount the Fiber CAP L
The following graphic provides an exploded view of how the different components of the Hybrid Splice
Box Mounting Kit come together.
Angled Mounng Bracket
Flange-head screw
M6-1.0 x14mm screw
Hybrid Fiber
Splice Box
Wall Bracket
4
Put a flange-head screw halfway into the top screw holes on the side of the Angled Mounting Brackets.
5
Lift the CAP L so you can align the two flange-head screws with the mounting slots on the Wall Mounting
Bracket, and then lower the CAP L so that it hangs on the Wall Mounting Bracket.
6
Attach the bottom two flange-head screws.
7
Tighten all four flange-head screws.
8
Attach the cables running from the bottom of the CAP L Hybrid Fiber Splice Box Kit.
a
Attach the Local Power Jumper to the CAP L power connector.
b
Attach the Fiber Patch Cord to the CAP L Port 1; the other end was attached in Step 4c ( page 44 ) to
one of the cable glands.
9
After you mount the CAP L with a CAP L Hybrid Fiber Splice Box Kit, follow the steps in
•
"Ground the Fiber CAP L (Optional)” on page 55 (if grounding is required or preferred)
•
"Connect the Passive RF Antenna” on page 59 .