CommScope Era, Руководство по установке

Страница: 30 / 71

CommScope Era
™
Fiber Low Power Carrier Access Point Installation Guide M0201ANC_uc
Page 26 © June 2019 CommScope, Inc.
Mount the Fiber CAP L
Attach the Flat Mounting Bracket Kit to the CAP L
Attach the two mounting brackets to the back of the CAP L enclosure as described below and as shown in
Figure 7 (Fiber CAP L with a Fan Kit) and Figure 8 on page 27 (Fiber CAP L without Fan Kit).
1
Use "Plan and Prepare for a Fiber CAP L Installation” on page 10 to identify the installation site and
installation requirements, and to prepare for this installation.
2
Refer to and observe all cautions listed in "General Mounting Cautions” on page 24 .
3
Use three of the M6-1.0 x14mm screws that came with the Flat Mounting Bracket Kit to attach the left or
top mounting bracket to the three corresponding horizontal or vertical M6-1.0 mounting taps on the back
of the CAP L chassis.
4
Use three of the M6-1.0 x14mm screws that came with the Flat Mounting Bracket Kit to attach the right
or bottom mounting bracket to the three corresponding horizontal or vertical M6-1.0 mounting taps on
the back of the CAP L chassis.
One Mounng bracket
in horizontal posion
Three
M6-1.0 x 14mm
screws
One Mounng bracket
in horizontal posion
Three M6-1.0 x 14mm screws
Figure 7. Fiber CAP L (No Fan Kit) with Flat Mounting Bracket Kit (PN 7774353-xx)