CommScope Era, Руководство по установке

Страница: 9 / 71

M0201ANC_uc CommScope Era
™
Fiber Low Power Carrier Access Point Installation Guide
© June 2019 CommScope, Inc. Page 5
Fiber CAP L Overview
F
IBER
CAP L O
VERVIEW
There is one Optical Fiber and two Copper CAP L interface variants. This installation guide describes the Fiber
CAP L, which interfaces with a Classic CAN or TEN via an optical link. This allows the Fiber CAP L to provide
data over Single-Mode Fiber (SMF) or Multi-Mode Fiber (MMF). Power for Fiber CAP Ls is provided over
External AC/DC or remotely through hybrid fiber.
On the downlink, the Fiber CAP L converts data arriving at the CAP L to analog signals and sends them to the
Antenna ports. On the uplink, received signals are digitized and serialized into data streams, which are sent
back to the Classic CAN or TEN.
Figure 1 shows how a Fiber CAP L can be deployed in an Era system.
e-POI
Classic
CAN
eNode B
TEN
UAP
UAP
UAP
UAP
* Power can be on AP side (AC or DC)
or be remote with composite fiber (DC)
TEN
Cat6A cable
Fiber
Power
Power*
Fiber CAP L
Fiber CAP L
Fiber CAP L
Fiber CAP L
Fiber CAP L
Fiber CAP L
Fiber CAP L
Fiber CAP L
Fiber CAP L
Fiber CAP L
Figure 1. Fiber
CAP L
in an Era System
The Fiber CAP L
•
has the following temperature ranges
–
without a Fan Kit, it is passively cooled with a temperature range of: -33°C to +40°C (-27.4°F to
104°F); see also
"Extended CAP L Temperature Operation” on page 22 .
–
with a Fan Kit, the Fiber CAP L has an increased maximum operating temperature of 55°C (131°F);
see also
"Fan Kit” on page 7 .
•
is outdoor rated (IP67)
•
has a typical power consumption that dependent on the model ranges from 92 to 103W; see "Required
Antenna Distances” on page 16 .