EQUIPMENT MANUAL FOR RD-9120
RD-9120 QE
Copyright - refer to title page
Page 25
ENU Status : 1-0-0
3.4.2 WALL MOUNTING DETAILS
This manual takes mounting the equipment with relatively small enclosure as an example.
Mount the equipment to the wall according to the following steps:
1.
Drill four holes on the wall using the mounting rack as a guide. Then fix the mounting rack to the wall
using four masonry bolts (M10X110). If the mounting surface is not solid enough, insert two more
masonry bolts to the upper mounting rack.
2.
Raise the enclosure and position it over the mounting rack, hook the enclosure onto the mounting
rack from the upper corners.
3.
Tighten the two recessed hex socket bolts (M8X80) at the lower corners to secure the enclosure to
the mounting rack.
4.
After local commissioning, close the door, tighten the hex socket bolts (M8X25) at the corners of the
enclosure with the allen key and lock the door.
Door lock
Alignment Fixture
Wall
Masonry Bolt M10
×
110
Mounting Rack
Plain Washer M10
Nut M10
Allen key
Hex socket bolt M8x25
Recessed
Hex socket bolt M8x80
Figure 6: Wall mounting overview
