InteliLite
NT
– AMF20/25, SW version 1.2, ©ComAp – March 2008
44
IL-NT-AMF-Reference Guide1.2.pdf
Starting
RPM
RP
M
BO Starter
BO IDLE/RATED
RPM = 2
RPM
Start Fail
Idle Time
Min Stab Time
Electric protections
active
Hint:
If the IDLE function not supported on the governor, set the
Idle Time
nevertheless to minimum 5s to
avoid
Underspeed
possibly caused by instability of the engine short after start.
Min
Stab
Time
[s]
Minimum time after reaching of defined level of RPM to the closing GCB.
Step:
1s
Range:
1 – 300 (Max Stab Time) s
Max
Stab
Time
[s]
Maximum time after start to get proper voltage level of the generator.
Step:
1s
Range:
1 (Min Stab Time) – 300 s
Hint:
When generator voltage within
Max Stab Time
does not reach defined limits (Generator protection
group) , an alarm occurs and the gen-set will shut down
Cooling
Time
[s]
Runtime of the unloaded gen-set to cool the engine before stop.
Step:
1s
Range:
0 – 3600 s
Hint:
Cooling is executed at nominal speed and generator protections are active.
Stop
Time
[s]
Under normal conditions the engine must certainly stop within this period. The period starts by issuing
stop command.
Step:
1s
Range:
0 – 240 s
Hint:
Stop of engine is detected when all following conditions are met: RPM <2, Oil pressure <
Starting Oil P
Generator voltage < 10 VAC and D+ input isn’t active.
Stop fail is detected when there is difference between those conditions, e.g RPM<2 and Generator
voltage > 10V.
Fuel Solenoid
[ DIESEL / GAS ]
Determines behavior of the Binary output FUEL SOLENOID.
DIESEL: Output closes 1 sec before Binary output STARTER.
The output opens if Emergency Stop comes or Cooled gen-set is stopped and in pause
between repeated starts.
