Colin BP-S510, Руководство по эксплуатации

Страница: 82 / 137

76
CAUTION: Be sure to dispose of discharged gas in order to prevent pollution of
treatment room.
CAUTION: Do not reuse discharged gas in order to prevent the spread of infectious
diseases.
1. Connect the sample line in the following manner:
1 To main unit 3 Nafion tube
2 Sampling tube 4 Airway adapter
Figure 44. Connecting the sample line
2. Check the volume of water in the water trap on the monitor’s left panel.
Warming Up
The monitor requires maximum of 3 minutes to warm up after the power has been turned
on. After the warm-up has finished, auto atmosphere calibration will commence.
Sample Line Checks
WARNING: Do not use the device if the “Occlusion” message has not displayed
after the sample line was seal-checked, as measurement readings will be
incorrect.
Check to see that the sample gas is not diluted. If gas is diluted, measurement readings
will be affected due to intake of external air from some point.
1. Seal both ends of the airway adaptor (see diagram below).
2. After a few seconds, check to see that the “Occlusion” message
appears on screen and then unseal the ends of the airway
adaptor.
3. Press the jog dial to return to normal measurement.
If the “Occlusion” message does not appear, there is probably a
loose connection or leakage, so check each part of the setup.
Key points of attention:
9 Occlude the inlet port of the water trap to see which side of the patient circuit may be
the problem
9 Also replace components to see if that solves the problem.