Colin BP-S510, Руководство по эксплуатации

Страница: 45 / 137

39
a. The monitor begins to track the physiological signal from the simulator.
b. After about 10 to 20 seconds, the monitor displays the value measured as
specified by simulator. Verify values are within the tolerances specified in
Specification section for each parameter (ECG, SpO
2
, NIBP, Temp, RESP,
IBP, EtCO
2
).
c. Audible alarm sounds.
d. Visual alarm Indicator on the front panel flashes.
e. “
Lower limit violated
” message is displayed.
f. The numerical area flashes, indicating the parameter has violated default alarm
limits.
Changing Alarm Limits
WARNING: Each time the monitor is used, check alarm limits to make sure that
they are appropriate for the patient being monitored.
You can change alarm limits from default values, if necessary.
Alarm limits or Alarm suspension may be set in two ways:
z
Via interaction with
HR/PR, SpO
2
, NIBP, Respiration, Temperature, CO
2
and
IBP
menu
or
z
Via interaction with
Alarm limits menu
that presents the limits in all the parameters
at one time
Setting Alarm Limits via Alarm Limits Menu
1. Rotate the jog dial to highlight
Alarm limits icon
on the lower of the screen, then press
the jog dial to display
Alarm limits menu
Figure 16. Alarm Limits Menu
2. Press the jog dial to select
Alarm limits
. The monitor will display all alarm limits that
are currently in effect for all monitored parameters. Select the alarm limits to set.