Colin BP-S510, Руководство по эксплуатации

Страница: 112 / 137

106
Cleaning
The monitor may be surface-cleaned by using a soft cloth dampened with either a
commercial, nonabrasive cleaner or one of the solution listed in the below. Lightly wipe
the top, bottom and front surfaces of the monitor lightly.
z 70% Isopropyl alcohol
z 10% Chlorine bleach solution
For cables, sensors, cuffs, and probes, follow the cleaning instructions in the directions
for use shipped with those components.
Avoid spilling liquid on the monitor, especially in connector areas. If liquid is accidentally
spilled on the monitor, clean and dry thoroughly before reuse. If in doubt about monitor
safety, refer the unit to qualified service personnel for checking.
Battery Maintenance
CAUTION: Recharging the battery is strongly recommended when the battery has
not been recharged for 2 or more months.
CAUTION: Follow local government ordinances and recycling instructions
regarding disposal or recycling of device components, including batteries.
If the monitor has not been used 2 months, the Ni-MH battery will need charging. To
charge the battery, connect the monitor to an AC power source as described in the
Battery Operation section.
Note: Storing the monitor for a long period without charging the battery may degrade the
battery capacity. A full charge of a depleted battery takes over 12 hours
Note: The service menu displays the number of deep discharge cycles seen by the
battery. The monitor records a deep discharge cycle when the battery reaches the
voltage at which a “Critically low battery” alarm is issued. Refer to the service
manual for the details.
Note: The battery should be removed from the monitor if placed in storage or will not be
used for a long period.
Colin Medical Technology recommends that the monitor’s Ni-MH battery be replaced if it
has been stored for 2 years or more. Refer to the monitor service manual for battery
replacement and general service instructions.