TM
25
6.4 Print test with SD Card
6.4.1 After nozzle and filament inspection, the screen will show as below
picture R. The printer will start to heat up the platform a few minutes.
NOTE: If screen shows no test file such as picture S, means that the test file
cannot be found n SD card. Check the following.
1. Check if the SD Card is inserted into the SD card slot well.
2. Check if the test file is saved in the SD Card. The test file name will be
updated base on the shipped printer,
(For example: PDT2.gco for PLA filament and ADT2.gco for ABS filament)
6.4.2 Once the platform temperature reach the setting temperature,
the nozzle will heat up next as picture T.
Filament
Nozzle
Setting
Temperature
Platform Setting
Temperature
PLA
205
℃
65~70
℃
ABS
230
℃
100
~110℃
R
Platform Actual Temperature
Platform Setting Temperature
NOTE:
The platform setting temperature for
PLA and ABS is different . Incorrect
temperature setting will result in the
object sticking on the platform.
S
T
