Cold Jet 514635, Руководство пользователя

Страница: 52 / 105

Industrivej 62
DK-6740 Bramming
Denmark
Original
Revision: 2.0
IceTech R1000H
Procedures for Maintenance and Repair
Page:
5-19 of
32
Date: 24.08.18
Init: JM
Drive the piston a bit into the chamber. With little force it should be possible to move the piston in all
directions. The super bolts
[ 4 ] should then be tightened according to following procedure:
APPLY GREASE (4A0001) BOTH ENDS AND TORQUE AS SHOWN IN SUPERBOLT CATALOG (PG 27-28) 9 FT-
LBS (12.2NM) ON ALL 4 NUTS, THEN 18 FT-LBS (24.4NM) ON ALL 4 NUTS, THEN 27 FT-LBS (36.6NM) ON
ALL 4 NUTS
Refill the hydraulic oil if necessary. Before resuming production it’s important to check the offset on the
linear encoder.
BEFORE STARTING PRODUCTION THE HYDRAULIC MOTION SHOULD BE CHECKED IN MANUAL MODE!