Citrix NetScaler EE, Руководство по установке и настройке

Страница: 636 / 1026

© 1999-2017 Citrix Systems, Inc. All rights reserved. p.636 https://docs.citrix.com
Provisioning the Appliance
Aug 12, 2014
After assigning an IP address to the management service, you are ready to provision the NetScaler and accelerator
instances. As soon as you log on to the appliance, the configuration wizard appears.
When using the configuration wizard, keep the following points in mind:
The following procedure assumes that you have already filled out the configuration worksheet.
If you change the IP addresses of the Management Network, or change the default gateway to an address not on the
Management Network, you lose connectivity to the appliance unless you are on the same Ethernet segment as the
management port.
When using the configuration wizard, check your entries carefully. The wizard has no Back button. If you need to modify
the previous screen, use the Back button on your browser. This takes you to the logon page, then to the previous
screen.
The configuration wizard is displayed only when you log on to the appliance for the first time to configure the appliance.
After you finish configuring the appliance, this wizard becomes inaccessible, and will reappear only after a factory reset.
Check your entries carefully.
This wizard walks you through a fresh configuration of the appliance.
Note: If you receive a
#SESS_CORRUPTED
error at any time during these procedures, click Logout, clear your browser
cache, close your browser, and open it again.
To configure the appliance by using the configuration wizard:
1. On the Welcome page, click Get Started.
Note: All pages after the Get Started page have a heading that says, “Deployment Mode: Inline/L2 Mode,” but this
wizard is used for all deployment modes.
2. Follow these steps to configure a fully 7.3-compliant system:
Acquire the following release 7.3 software distributions from the release 7.3 downloads page on My Citrix:
Management service (as a .tgz file)
NetScaler VM (as an .xva file)
Accelerator VM (as an .xva file)
Upgrade bundle (as a .upg) file
Navigate to the System > Configuration > Management Service > Software Images page, and then select Upload
from the Action list.
Upload a release 7.3 Management Service image (distributed as a .tgz file).
Navigate to the System > Configuration > NetScaler > Software Images page, and then upload a release 7.3
NetScaler XVA image.
Navigate to the System > Configuration > SD-WAN > Software Images page, and then upload the accelerator XVA
image.
Navigate to the System > Configuration > Management Service page, and then click the Upgrade Management
Service link.
Select the management service image that you recently uploaded and click OK.
When the lower left-hand corner of the screen displays “Management Service Updated Successfully,” log off and
clear your browser cache. Log on after the management service restarts (a few minutes).
On the Welcome screen, click Get Started.
3. For Management Access Settings, specify values for the various fields according to the network settings. The following