Citrix NetScaler EE, Руководство по установке и настройке

Страница: 425 / 1026

© 1999-2017 Citrix Systems, Inc. All rights reserved. p.425 https://docs.citrix.com
Configuring the Appliance by Connecting a Computer
to the Ethernet Port
Aug 12, 2014
For initial configuration of a SD-WAN appliance, perform the following tasks::
Configure the appliance for use on your site.
Install the Citrix license.
Enable acceleration.
Enable traffic shaping (inline mode only).
With inline deployments, this configuration might be all you need, because most acceleration features are enabled by
default and require no additional configuration.
You can configure the appliance connecting the appliance to your computer through either the Ethernet port or the serial
console. The following procedure enables you to configure the appliance by connecting it to your computer through the
Ethernet port.
If you want to configure the appliance by connecting it to the computer through the serial console, assign the
management service IP address from your
Worksheet by completing the Assigning a Management IP Address through the
Serial Console procedure, and then run steps 4 through 25 of the following procedure.
Note: Make sure that you have physical access to the appliance.
T o conf igure t he appliance by connect ing a comput er t o t he SD-WAN appliance’s Et hernet port 0/1
T o conf igure t he appliance by connect ing a comput er t o t he SD-WAN appliance’s Et hernet port 0/1
1. Set the Ethernet port address of a computer (or other browser-equipped device with an Ethernet port), to
192.168.100.50, with a network mask of 255.255.0.0. On a Windows device, this is done by changing the Internet
Protocol Version 4 properties of the LAN connection, as shown below. You can leave the gateway and DNS server fields
as blank.
2. Using an Ethernet cable, connect this computer to the port labeled MGMT on a SD-WAN 1000 appliance with Windows
Server, or to the port labeled PRI on a SD-WAN 2000 appliance with Windows Server.
3. Switch on the appliance. Using the web browser on the computer, access the appliance by using the default
management service IP address http://192.168.100.1.
4. On the login page, use the following default credentials to log on to the appliance:
Username Username: nsroot
Password Password: nsroot.
5. Start the configuration wizard by clicking Get St art ed Get St art ed.
6. On the Platform Configuration page, enter the respective values from your worksheet, as shown in the following
example:
Note: If, for configuration, you want to use the same network mask and gateway as those for Network Configuration,
select the Use Syst em Net mask and Gat eway
Use Syst em Net mask and Gat eway option.
7. Click Done Done. A screen showing the
Installation in Progress…
message appears. This process takes approximately 2 to 5
minutes, depending on your network speed.
Note: If you are configuring the appliance by connecting it to your computer through the serial console port, skip step 8