Citizen CT-P29 Series, Справочник по командам

Страница: 119 / 428

- 118 -
ESC u n
(Valid in CBM1000-Compatible Mode)
Support model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251
CT-S281 CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310 II
[Function] Sending the peripheral device status
[Code] <1B>H<75>H<n>
[Outline] [The specification which is common to the model]
• Send the current drawer kick connector pin#3 status.
• n has the type shown in the table below:
n Connector Pin
0 Drawer kick connector pin#3
[Caution] [The specification which is common to the model]
• Status to be sent uses 1 byte that has the value listed in the table below.
• DTR/DSR control sends 1 byte only after checking that host is ready to receive (DSR signal: space status). For
XON/XOFF control, 1 byte is sent without checking DSR signal status.
• For DTR/DSR, if host is not ready to receive (DSR signal: mark status), it waits for ready condition to receive.
• Paper-end status causes BUSY status, thus this command may be in the receive-not-ready status.
• This command is valid only when MSW3-7 is set to ON.
Bit Function
Value
0 1
0 Pin #3 level ‘L’ ‘H’
1 Undefined
- -
2 Undefined
- -
3 Undefined
- -
4 Unused 0: Fixed -
5 Undefined - -
6 Undefined - -
7 Undefined - -
[Sample Program]
OPEN "COM1:N81NN" AS #1 -> OPEN statement depends on types of BASIC.
PRINT #1,CHR$(&H1B);"u";CHR$(0)
A$ = INPUT$(1, #1)
CLOSE #1