Citizen CT-P29 Series, Справочник по командам

Страница: 93 / 428

- 92 -
GS
\
nL nH
Support model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251
CT-S281 CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310 II
[Function] Specifying the relative vertical position of a character in PAGE MODE
[Code] <1D>H<5C>H<nL><nH>
[Range]
0≤nL≤255, 0≤nH≤255
[Outline] [The specification which is common to the model]
• This command is used in PAGE MODE to specify the vertical position of a character in the data mapping start
position, in a relative position with respect to the current position.
• The next data mapping start position will be at a point [(nL+nH×256)×basic calculation pitch] inches away
from the current position.
[Caution] [The specification which is common to the model]
• This command is ignored when PAGE MODE is not selected.
• If a new position is specified for a character located beneath the current position, it should be specified as
positive (+). If it is above the current position, it should be negative (–).
• A negative value is the complement of 65536. For example, to move the position by N pitches up, specify it
as: nL + nH x 256 = 65536 – N
• The specification of a relative position outside the specified print area is ignored.
• Depending on the start point specified by ESC T, this command acts as follows:
(1) If the start point is the top left or bottom right, the command specifies the relative position in the paper
feed direction (the character’s top-bottom direction) using the vertical basic calculation pitch (y).
(2) If the start point is the top right or bottom left, the command specifies the relative position in the direction
perpendicular to the paper feed (the character’s top-bottom direction) using the horizontal basic
calculation pitch (x).
• The basic calculation pitch is set by GS P.
• Fractions resulting from calculations are corrected with the minimum pitch of the mechanism, and the
remainder is omitted.