Cissell FFCD, Руководство пользователя

Страница: 9 / 33

Page 9
CISSELL FORM FINISHER
(Operating Instructions)
Read General Information on Preceding Pages Before Reading Operating Instructions below.
-IMPORTANT-
For best performance, and maximum production, avoid unnecessary adjustments. Finish, in sequence,
garments of same size and type. This will eliminate adjusting waist, hip, or lower controls for each
garment; increase production, and provide maximum life for the nylon form. Time can also be saved
by finishing small garments first, then progressively moving from group to group, until largest size and
type is reached.
Selection from unfinished garments may be made by the operator directly from the incoming speed
rail, without separate sorting, classifying or grouping. It is best to REDUCE FORM TO ITS SMALL-
EST SIZE WITH AIR OFF, or with AIR CONTROL in Minimum Setting. Controls can be released
easily to allow air to expand form to size of garment with AIR ON.
AIR CONTROL
AIR PRESSURE - can be adjusted, at front of machine, from maximum to minimum, or to any interme-
diate stage. Markings 1-2-3 help operator to identify air pressure for repeat operations of similar
garments.
FOR HEAVY GARMENTS, keep air in maximum position, or adjust to any lower pressure
desired during step number 2 under finishing instructions.
FOR SHEER, delicate fabrics, reduce air to minimum or adjust to any higher pressure desired
during step number 2 under finishing instructions.
COAT FINISHING
Open Arm Zippers in Nylon Form for All Garments With Sleeves; Keep Closed for Sleeveless Gar-
ments.
1. PLACE COAT ON FORM FINISHER. With each hand, grasp front edges of coat lapels just
below gored seams. Swing coat over and around form and place coat to hang evenly. STRAIGHTEN
COAT - pocket flaps, collar lapels, etc.
Pull two front edges of coat forward; overlap front edges at least 3” from bottom of coat to
lapels with buttons on outside; close front clamp. Front clamp raises or lowers 5” to permit proper
positioning for long or short coats. Close back clamp on rear vent of topcoats, raincoats, or overcoats.
(Place separate vent clamp on rear vent of extremely short garments.)