Cissell FFCD, Руководство пользователя

Страница: 7 / 33

Page 7
TO CONNECT STANDARD, SINGLE PHASE MACHINE TO THREE PHASE CURRENT, connect
the black and white power leads of the Finisher to any two terminals of an approved fused disconnect
switch in the three phase power line.
IMPORTANT: Consult your local electrical code, before making any electrical connections, and be
certain that the electrical installation conforms with all local requirements.
Always check wiring before closing the disconnect switch.
Operate the Steam Cycle a couple of times before installing the Revolving Assembly.
OPEN SLEEVE ZIPPERS ON EACH SIDE OF FORM; insert hand through zipper openings, and
remove paper between shoulder form and nylon form, which is a
protective covering for shipping only. Remove paper covering on front and rear clamps; grip handles
of front and rear clamps, and replace revolving form on base. Finisher is now ready for operation.
REMOVE NYLON FORM from finisher at frequent intervals for cleaning, as determined by its soiled
condition. WET clean only ... do NOT dryclean. After wet cleaning, the nylon form should be ex-
tracted and blown dry on a wind whip. KEEP NYLON FORM CLEAN. Nylon Fabric acts as a filter
in operation, collecting dust and lint, etc., which clogs pores of fabric, greatly reducing its efficient
operation. FAILURE to keep form clean may cause transfer of soil from form to lining of garments.
REPAIR HOLES OR WORN SPOTS in nylon form to extend its useful life; REPLACE when holes or
worn spots are beyond repair. A defective or worn nylon form will cause the machine to operate
unsatisfactorily.
CAUTION
Use only genuine CISSELL FD10 or FG10 replacement Nylon Forms for best results. The fabric for
Cissell Nylon Forms is especially woven (and cut to an exact pattern) to give the correct porosity for
proper steaming and drying. Remember, your CISSELL Form Finisher depends entirely on the Nylon
Form for proper operation.