Cissell FFCD, Руководство пользователя

Страница: 18 / 33

Page 18
CISSELL FORM FINISHER
INSTALLATION OF NYLON BAG
and Waist, Hip, and Lower Draw Cables
(Lever Type Controls)
For Form Finisher Serial No. 14,000 to -
TO REMOVE BAG
FIRST: Lock hip, waist, and lower controls in LARGE position. Untie draw strings
(A).
SECOND: Lift bottom of bag for access to Lower Draw Cable. Snap swivel from bead
(B); pull cable from eyelet (D). Repeat procedure on opposite side of bag.
THIRD: Lift bottom of bag for access to Hip Draw Cable. Snap swivel from bead (E);
pull cable from eyelet (F). Repeat procedure on opposite side of bag.
FOURTH: Lift bottom of bag over shoulder for access to Waist Draw Cable. Snap swivel
from bead (G). Repeat procedure on opposite side of bag.
FIFTH: Lift bag from form.
IMPORTANT
Before installing bag, be certain that single draw cable (L) is connected at (K) and feeds down thru eyelet
(M) to position (B). This cable must operate outside of frame (N) and (P). Keep other draw cables to
outside of cable (L).
NOTE: If other draw cables get between cable (L) and frame (N) and (P), the lower draw cable will not
operate properly.
TO INSTALL NYLON BAG
FIRST: Slip bag over form with Cissell label at front. Be certain that right draw
cables within bag hand at right side; left draw cables hang at left side. Move
shoulders to maximum width and center bag on form.
SECOND: Lift bottom of bag over shoulder for access to Waist Draw Cable.
THIRD: Pull Cable taut and DOWN through eyelets (J) and (H). Snap swivel securely
on bead (G). Repeat procedure on opposite side of bag.
FOURTH: Lower bottom of bag from shoulder for access to Hip Draw Cable. Pull cable
taut and UP through eyelet (F). Snap swivel securely on bead (E). Repeat
procedure on opposite side of bag.
FIFTH: Lower bottom of bag for access to Lower Draw Cable. Pull cable taut and UP
through eyelet (D). Snap swivel securely on bead (B). Repeat procedure on
opposite side of bag.
SIXTH: Slip bag over rim at bottom of frame. Align and tie draw strings (A) securely.
After tying, position ring tapes (R) as illustrated.
IMPORTANT
If nylon bag does not fully expand when controls are in Large position, add extra bead chains (furnished)
between couplings to lengthen draw cable. Add necessary beads at (B), (E) or (G), as required.