Cissell FFCD, Руководство пользователя

Страница: 13 / 33

Page 13
CISSELL FORM FINISHER
INSTRUCTIONS FOR ADJUSTING HEIGHT OF REVOLVING FORM
Should the revolving form “drag” on the Form Finisher base rather than turn freely, the form must be
raised.
Conversely, if the revolving form rides too high above the Form Finisher base, permitting steam to
escape from the space between the form and base, the form must be lowered.
WHEN AN ADJUSTMENT MUST BE MADE, REMOVE REVOLVING FORM BY SIMPLY LIFT-
ING IT STRAIGHT UP OFF THE FORM FINISHER BASE
PROBLEM: Revolving Form “drags” on base of Form Finisher
TO CORRECT: Loosen Bearing Lock Nut.
Turn Bearing Adjustment Screw COUNTER-CLOCKWISE.
CHECK ADJUSTMENT: Replace revolving form on Form Finisher base. Rotate form. If perfectly
adjusted, form will rotate freely and snugly on felt seal around top of base. If form is still too low...or
too high...repeat adjustment until it is correct.
PROBLEM: Revolving Form rides too high above Form Finisher base.
TO CORRECT: Loosen Bearing Lock Nut.
Turn Bearing Adjustment Screw CLOCKWISE.
CHECK ADJUSTMENT: Replacement revolving form on Form Finisher base. Rotate
form. If perfectly adjusted, form will rotate freely and snugly on felt seal around top of base. If form
is still too high...or too low...repeat adjustment until it is correct.