Single Point Setup
Access Points
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE
165
10
STEP 4
(Optional) In the Location field, enter a description of where the access point is
physically located, for example, Reception.
STEP 5
Click
Enable Single Point Setup
.
The access point automatically joins the Single Point Setup.
Removing an Access Point from a Single Point Setup Cluster
To remove an access point from the Single Point Setup cluster:
STEP 1
In the table showing the detected devices, click the IP address for the clustered
WAP device you want to remove.
The web-based configuration utility for that WAP device shows.
STEP 2
Select
Single Point Setup > Access Points
in the navigation pane.
STEP 3
Click
Disable Single Point Setup
.
The
Single Point Setup
status field for that access point will now show
Disabled
.
Navigating to Configuration Information for a Specific WAP
Device
All WAP devices in a Single Point Setup cluster reflect the same configuration (if
the configurable items can be propagated). It does not matter which WAP device
you connect to for administration—configuration changes on any WAP device in
the cluster are propagated to the other members.
There may be situations, however, when you want to view or manage information
on a particular WAP device. For example, you might want to check status
information such as client associations or events for an access point. In this case,
you can click the IP address in the table on the Access Points page to show the
web-based configuration utility for the particular access point.