Chapter 5 Setting Up Discovery and Device Management
Discovering Devices
5-10
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16778-01
If the summary is not correct, click
Back
to make changes in any of your settings.
Step 8
A popup message displays the name of the discovery and the Discovery Run
Details window appears. Click
Refresh
to update the Job Run Log.
Modify the CDP Discovery Schedule
To modify the default discovery schedule, perform the following steps:
Step 1
Select
Devices
>
Discover > Discover > Discovery Wizard.
Step 2
Select
Automatic Device Discovery based on Cisco Discovery Protocol,
and
click
Next
.
Step 3
Select
Modify Periodic
and click
Next
.
Step 4
To modify the schedule:
a.
Select the Start Date and Start Time from the pull-down lists.
b.
To repeat discovery at a specified interval, select
Enable
. Then enter a
number for the interval and select Minutes, Hours, Days, Weeks or Months
from the pull-down list.
c.
Click
Next
.
Step 5
If you already added community strings, click
Next
.
If you have not added community strings, you must add them now. For details on
adding community strings, see
Enter SNMP Community Strings for All Managed
. After adding community strings, click
Next
.
Step 6
Add one or more initiating IP addresses (seeds):
Note
If CDP is not enabled, you still can discover devices by entering each of
their IP addresses as seeds in this window, however the connectivity
between switches and access points will not be discovered.
a.
Enter the IP addresses or device names in the Add Seed Values text box and
click
>>
.
