Chapter 3 Setting Up the WLSE
Configuring the WLSE’s Network Information
3-2
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16778-01
Configuring the WLSE’s Network Information
Use the setup program to configure the WLSE when you boot it for the first time,
and after erasing the configuration.
Guidelines for Using the Setup Program
When using the setup program:
•
Press the
Backspace
or
Delete
key to delete characters when entering a
response to a prompt.
•
You cannot edit a response after you press the
Enter
key. You can use CLI
commands to change some responses after running setup; see
Configuration After Running Setup, page 3-5
.
•
You can exit the setup program in two ways:
–
Press
Ctrl-c
.
The login prompt appears. Log in as the user
setup
to rerun the setup
program.
–
Enter
no
at the final prompt:
Would you like to save this configuration? [yes].
The setup program exits without saving the configuration, then restarts.
and
for the data you will need to
enter into the setup prompts.
Running the Setup Program
To configure WLSE network information, perform the following steps:
Step 1
Connect a console terminal or PC to the serial/console port on the back panel.
Do
not use the video port for this purpose
.
