Chapter 2 Installing WLSE 1130-19 Hardware
Preparing to Install WLSE 1130-19 Hardware
2-4
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16778-01
Warning
The power supply circuitry for the equipment can constitute an energy hazard.
Before you install or replace the equipment, remove all jewelry (including
rings, necklaces, and watches). Metal objects can come into contact with
exposed power supply wiring or circuitry inside the DSLAM equipment. This
could cause the metal objects to heat up and cause serious burns or weld the
metal object to the equipment.
Statement 207
Warning
Ultimate disposal of this product should be handled according to all national
laws and regulations.
Statement 1040
Warning
Before working on a system that has an on/off switch, turn OFF the power and
unplug the power cord.
Statement 1
Warning
Read the installation instructions before connecting the system to the power
source.
Statement 1004
Warning
The ports labeled “Ethernet,” “10BaseT,” “Token Ring,” “Console,” and “AUX”
are safety extra-low voltage (SELV) circuits. SELV circuits should only be
connected to other SELV circuits. Because the BRI circuits are treated like
telephone-network voltage, avoid connecting the SELV circuit to the telephone
network voltage (TNV) circuits.
Statement 22
Warning
There is the danger of explosion if the battery is replaced incorrectly. Replace
the battery only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufacturer’s
instructions.
Statement 1015
