2-447
Cisco Catalyst Blade Switch 3030 Command Reference
78-17262-01
Chapter 2 Cisco
Catalyst
Blade Switch 3030 Cisco IOS Commands
spanning-tree link-type
spanning-tree link-type
Use the
spanning-tree link-type
interface configuration command to override the default link-type
setting, which is determined by the duplex mode of the interface, and to enable rapid spanning-tree
transitions to the forwarding state. Use the
no
form of this command to return to the default setting.
spanning-tree link-type
{
point-to-point
|
shared
}
no spanning-tree link-type
Syntax Description
Defaults
The switch derives the link type of an interface from the duplex mode. A full-duplex interface is
considered a point-to-point link, and a half-duplex interface is considered a shared link.
Command Modes
Interface configuration
Command History
Usage Guidelines
You can override the default setting of the link type by using the
spanning-tree link-type
command. For
example, a half-duplex link can be physically connected point-to-point to a single interface on a remote
switch running the Multiple Spanning Tree Protocol (MSTP) or the rapid per-VLAN spanning-tree plus
(rapid-PVST+) protocol and be enabled for rapid transitions.
Examples
This example shows how to specify the link type as shared (regardless of the duplex setting) and to
prevent rapid transitions to the forwarding state:
Switch(config-if)#
spanning-tree link-type shared
You can verify your setting by entering the
show spanning-tree mst interface
interface-id
or the show
spanning-tree interface
interface-id
privileged EXEC command.
point-to-point
Specify that the link type of an interface is point-to-point.
shared
Specify that the link type of an interface is shared.
Release
Modification
12.2(25)SEE
This command was introduced.
