CIAT AirCompact Control, Руководство по управлению

Страница: 62 / 69

62
5.5.3
Configuration process
The diagram below illustrates the phases of the "configuration process" required for configuring the card correctly:
The types of KNX Datapoint available and the respective conversion methods are listed in the table below:
Type
Name
Standard ID Format KNX range
Range available in
the controller
Boolean
(DPT_Switch) 1.001 1 bit Off / On Off / On
Unsigned 8 bit
(DPT_Value_1_Ucount) 5.010 Unsigned 8 bits 0 to 255 0 to 255
Signed 8 bit
(DPT_Value_1_Count) 6.010 Signed 8 bits -128 to +127 -128 to +127
Unsigned 16 bits
(DPT_Value_2_Ucount) 7.001 Unsigned 16 bits 0 to 65535 0 to 32767
Signed 16 bits
(DPT_Value_2_Count) 8.001 Signed 16 bits -32768 to +32767 -32768 to +32767
Floating 16 bits
(DPT_Value_Temp) 9.001 Floating 16 bits -671088.64 to
+670760.96 -3276.8 to +3276.7
It is important to remember that the same group address cannot be assigned to more than one Datapoint.
5.5.4
CAREL plugin
As is the case for other manufacturers' devices, the ETS3 data archives must be loaded with a specific description of the device.
CAREL distributes a plugin in the form of a "project database", which assigns the addresses and downloads the table created by
K-Set, i.e., the XML file.
5.5.5
Installing the plugin
The plugin is installed as follows:
. Find the file "Carel_plugin_21.pr4" (the updated version of the plugin is available from ksa.carel.com)
. Import "Carel_plugin_21.pr4" using
Files → Import
as shown below:
XML file
No group
addresses
kSET:
Enter the group
addresses
ETS3 project
.pr4 file
with the
CAREL Plugin
ETS3
Create the links
between the various
datapoints, i.e.,
allocate the group
addresses
XML file
complete
ETS3
Assign the addresses
to all the modules, and
configure products
other than CAREL
XML file
Download XML file to
the CAREL modules
(table with group
addresses)
END
of installation
OFF-line : linkage of variables
ON-line :
Download the configuration
Physical connection to
network required