Christie CP2000-X, Руководство пользователя

Страница: 87 / 164

BASIC OPERATION
CP2000-X User Manual
3-45
020-100031-01 Rev . 1 (03-2009)
Table 3.12. Sample Messages
Desired Action Message Description
Get current Chan# (CHA?) Request by controller for current channel #
Chan# reply from proj. (CHA!101) Reply from proj. that current channel is 101
Set Chan# (CHA 101) Switch to the first channel on the TPC
Get picture mute status (PMT?) Request by controller for picture mute status
Picture mute reply from proj. (PMT!000) Reply from proj. that picture is mute is off.
Set picture mute (PMT 1) Turn the picture mute on (blank the image)
Although you will send and read all messages as strings of ASCII characters, the
actual message travels as a sequence of bytes. Each character in a unicode message
requires 2 bytes, whereas the non-unicode requires only 1 byte. See example in
Figure 3.29 below, which illustrates a “picture mute is off” reply from the projector:
Figure 3.29. ASCII as Non-Unicode and Unicode
NOTE: Use of unicode or non-unicode in messages is auto-detected from the TPC.
All available ASCII message codes, including those with multiple parameters, are
listed and explained in
Appendix B .
SETUP:

In the Admin:General menu, define which users (all, none or some) have remote
access rights.

Open an Ethernet socket to the TPC address (socket = 5000). By default, the TPC
address is 192.168.206.
110 . If you have additional TPCs, the installer should
have defined their addresses as 192.168.206. 111 , 192.168.206. 112 , and so on, or
used other addresses that are valid for your site.

Communication protocol should now be established (and can be confirmed with
a PNG?, if desired).
NOTE:
The socket will automatically close after 15 minutes of inactivity. Program
your controller to send a PNG? message every 5-10 minutes to maintain
communication and keep the socket functioning.
IMPORTANT: To prevent shutdown of the socket, program the controller to send a
PNG? every 5-10 minutes.
SHUTDOWN:
You must close the application and shut down the socket properly
before shutting down the controller.
Sample Messages and

Their Meaning
What is Actually Sent

In a Message?
Available ASCII Codes

Setup and Shutdown
