Christie CP2000-X, Руководство пользователя

Страница: 109 / 164

Section 5
Non-cinema Operation
CP2000-X User Manual
5-1
020-100031-01 Rev . 1 (03-2009)
This section explains how to display “alternative content” originating from a standard
definition or high definition non-cinema source such as a PC or other graphics
devices, or from Christie’s
Cine-IPM 2K . Such a source routes to a DVI (Digital
Visual Interface) port in the CP2000-X projection head, and can bypass cinema
processing when necessary.
Make sure your non-cinema DVI source is
connected to
DVI-1
or
DVI-2
at the underside of the
CP2000-X projection head (Figure 5.1). These
connections are typically made at the time of
projector installation.
NOTES: 1)
You must first remove the access panel
located on the underside of the projector near the
air filter—see Figure 5.1. Drill an exit hole or
leave the panel off.
2)
For details about
connecting Christie’s Cine-IPM 2K , refer to the
Cine-IPM 2K User’s Manual supplied with the
device.
Each DVI port accepts and will auto-detect the
progressive-scan digital RGB sources listed in
Table 5.1, displaying most of them in their
original incoming format. Note that the projector
cannot scale DVI signals over 48 Hz to a different
size and/or aspect ratio.
Note that each DVI port is a single-link port for a
single-link cable/connector only. Using this pair
of ports as a higher-bandwidth dual-link or twin-
link pair requires additional hardware and is not
currently supported (see Figure 5.2).
5.1 Compatible
Non-cinema
Sources
Figure 5.1. Non-cinema DVI
Source Connection