BASIC OPERATION
CP2000-X User Manual
3-37
020-100031-01 Rev . 1 (03-2009)
RESTORE
NOTES:
This button enables you to return to the
Gamut
menu settings that
were present when you opened the menu, however the precise behavior depends on
whether you are working with
measured
(MCGD) or
target
(TCGD) settings.
To restore MCGD settings
: The Restore button is disabled unless you have used the
Test button. To cancel new MCGD settings and return to the previous MCGD
settings, the new settings must be tested (via Test button) but not yet saved. If not yet
tested, you can either leave the menu and cancel the settings as requested by the
dialogue box, or attempt to save but cancel out of it. If you have already saved a new
OnSite file (by pressing the Create MCGD), the old OnSite file cannot be restored.
To restore a TCGD FILE
: Press the Restore button any time before saving.
Admin/IP Config Submenu
Use the
IP Config
menu when you need to define or change the Ethernet settings—
i.e., network address—of the projector and/or its TPC.
NOTE:
Record any new settings on page 1-3 of this manual.
Figure 3.24. Admin:IP Config Menu Functions
Table 3.8. Summary of Admin:IP Config Menu Functions
ADMIN: IP CONFIG MENU FUNCTIONS
Projector vs. TPC Select which device address you wish to see or set.
Change Network Config Enter a checkmark to edit the Ethernet Configuration text boxes
defining the device’s address.
Host Name Enter a name for the projector (optional)
Obtain address from DHCP Allow the projector’s IP address to be auto-assigned by your
network’s DHCP server.
NOTE: Currently not supported.
Specify a Static IP Address Enter the full
valid
and
unique
address supplied by the network
administrator for using the device at this site.
IP Address The first three octets of the IP address identify the network to which
the device belongs; the last octet identifies the specific device (i.e.,
the projector or the TPC). Keep in mind that if you change the node
(any of the first 3 octets), the device will then belong to a different
network and will not interact until the other device is also changed
accordingly.
Subnet Mask All IP Addresses for a network belong to the same Subnet Mask as
defined by the network administrator.
Default Gateway Not used. All entries are ignored.
Apply Implement your current Ethernet Configuration settings. *
* Changes in the IP Config menu automatically change the projector IP address appearing in the Admin: General menu, which
identifies which projector the TPC is currently set to control.
Содержание CP2000-X
