Christie CP2000-X, Руководство пользователя

Страница: 56 / 164

BASIC OPERATION
3-14
CP2000-X User Manual
020-100031-01 Rev. 1 (03-2009)
STATUS:SYSTEM MENU ENTRIES
Processor Board
Diagnostics Performed
DSP
FPGA Load
FPGA Code Valid
FPGA Initialize
FPGA McBSP XRDY
FPGA Done
FPGA Register Read/Write
Serial ID Chip
CLUT SRAM
Overlay Framestore SDRAM
Resizer FIR Chip
Resizer FIFO
Other
System Supervisor Module Detected/Not Detected
Self Test OK/Failed
Ballast Communications OK/Failed
*  Can also be set to trigger a full-screen flashing red alarm window on the TPC. Note that if a DMD temperature
exceeds a certain factory-set threshold for at least 2 seconds, the lamp will automatically shut down. Recovery
requires that the DMD temperature fall to a safe factory-set threshold.
Figure 3.5. Flashing Alarm Window
In addition to the status bar at the bottom of any TPC screen, a full-screen red alarm
window flashes if one of the alarm conditions shown in the left column of Table3.2 is
encountered. If it is an interlock failure, power will no longer reach the lamp (DC
output is stopped), and the lamp button on the TPC
Main menu will be disabled.
See Table 3.2.
TPC Alarm Window
