Intelect TranSport®/Vectra Genisys® Ultrasound Therapy Systems
32
7.1 GENERAL PROCEDURES
A. Tools and Equipment Required
All Ultrasound Applicators for the unit being
serviced
Ohmic Instruments UPM DT 10 or UPM DT
100 ultrasound power meter, set to "Watts"
Degassed Water.
Refer to page 12
for
degassed water recipes
B. Ultrasound Applicator Calibration Procedures
1. Perform the following on all Ultrasound
Applicators annually or after repairing the
Applicator.
2. With the system on, press the Clinical
Libraries button once.
Refer to Figure 7.1.
3. Simultaneously press and hold the Treatment
Time and Intensity Decrease buttons for
approximately
2
seconds.
Refer to Figure 7.2
.
The calibration procedures screen should
display.
4. Press the Frequency button once to highlight
"Calibrate
Applicator".
5. Press the Intensity Display button once to
select.
6. Position the Ultrasound Applicator being
calibrated into the Ohmic Instruments UPM
UPM DT 10 or DT 100 power meter holder
and set meter to "Watts”.
Refer to Figure 7.3
.
7. Follow the instructions on the LCD Display.
8. When calibration is complete, repeat the
process with the remaining Applicators.
Follow the test procedures in
5.9 and 5.10
to verify that the Applicator is calibrated.
•
•
•
FIGURE 7.3
FIGURE 7.1
FIGURE 7.2
SET METER
TO WATTS
7 ULTRASOUND APPLICATOR CALIBRATION
Use only degassed water in power meter for
calibrating ultrasound applicators.
Use of other types of water will cause false readings
and bad test results.
See page 12
for degassed water recipes.
Use of other brands or types of tools, equipment,
fixtures, materials, and supplies other than those
specifically listed on
page 12
will give bad test and
calibration results.
If proper equipment is not available or cannot be
obtained, send the ultrasound applicators to the
factory for calibration.
