Page 50
Option 1 (Page 2) – Correction Factor
A correction factor is a multiplying factor that is applied to each axis individually.
By default the X and Y axis have a correction factor of 1.4 whereas the Z axis
has a correction factor of 1.0.
Press
1
on the keypad to enter the X Axis correction factor.
Press
2
to enter the Y Axis correction factor.
Press
3
to enter the Z Axis correction factor.
Enter the correction factor using the numeric keypad. The decimal point is
applied automatically.
Use the
Left Arrow
key
to delete unwanted input or press the
OK
key to
accept the inputted value. An Invalid input will give an ‘
Out of Range
’ error
message; the valid range is 1.0 to 2.0.
Press
Soft Key 1
labelled
CANCEL
to discard any changes or
Soft Key 4
labelled
APPLY
to make any changes made.
The correction factor is automatically applied to all displayed figures and results
where applicable.
Figure 50 – Correction Factors
1. X-Axis: 1.4
2. Y-Axis: 1.4
3. Z-Axis: 1.0
09:19:02
26:08:11
CRITERION
09:19:00
26:08:11
CRITERION
APPLY
CANCEL
CANCEL
1. X-Axis: 1.2
2. Y-Axis: 1.4
3. Z-Axis: _.
Press OK to accept
Numeric Entry Prompt
Select Axis
