Case 570NXT, Руководство оператора, Страница: 30 / 280

2 - SAFETY INFORMATION
Safety rules - Electrical storm safety
• Do no operate machine during an electrical storm.
• If you are on the ground during an electrical storm, stay
away from machinery and equipment. Seek shelter in
a permanent, protected structure.
• If an electrical storm should strike during operation, re-
main in the cab. Do not leave cab or operator's plat-
form. Do not make contact with the ground or objects
outside the machine.
Safety rules - Fire or explosion prevention
• Leaked or spilled fuel/oil on hot surfaces or electrical
components can cause a fire.
• Sparks from the electrical system or engine exhaust
can cause an explosion and fire. Before you operate
the machine in an area with flammable dust or vapors,
use good ventilation to remove the flammable dust or
vapors.
• Engine fuel can cause an explosion or fire. Do not fill
the fuel tank with the engine running, if you are near an
open fire, or if you are welding, smoking, etc.
• Do not weld or flame cut any items that contain
flammable material. Clean items thoroughly with
non-flammable solvent before welding or flame cutting.
• Always have a fire extinguisher near or on the machine.
Make sure the fire extinguisher(s) is maintained and
serviced according to the manufacturer’s instructions.
• If a fire extinguisher has been used, always recharge or
replace the fire extinguisher before operating the ma-
chine.
• Do not expose the machine to flames, burning brush,
or explosives.
• At least once each day, and at the end of the day, re-
move all trash and debris from the machine especially
around hot components such as engine, transmission,
exhaust, battery, etc. More frequent cleaning of the ma-
chine may be necessary depending on the operating
environment and conditions.
• At least once each day, remove debris accumulation
around moving components such as bearings, pulleys,
belts, gears, cleaning fan, etc. More frequent cleaning
of the machine may be necessary depending on the
operating environment and conditions.
• If the machine has an oil, fuel, or hydraulic fluid leak,
always repair the leak and clean the area before oper-
ating.
• Keep the cooling system clean and maintain the correct
coolant level.
• Do not store oily rags or other flammable materials on
the machine.
• Inspect the electrical system for loose connections or
frayed insulation. Repair or replace loose or damaged
parts.
• Promptly investigate any unusual smells or odors that
may occur during operation of the machine.
• If you weld, grind, or use a cutting torch on the machine:
• Clean the area to be repaired.
• Disconnect or isolate the drive train controller.
• Keep the ground cable from the welder as near to the
work area as possible.
• Sparks or flame can cause the hydrogen gas in a bat-
tery to explode. To prevent an explosion:
• Connect the negative (-) cable last.
• When connecting booster cables to start the engine,
use the procedure shown in this manual.
• Do not short circuit the battery posts with metal items.
• Do not weld, grind, or smoke near the battery.
2-6