Carver 42 SUPER SPORT, Руководство пользователя

Страница: 57 / 141

4127 • 42 Super Sport 4/06 45
AC ELECTRICAL SYSTEM SECTION 3
Receptacles - Salon
This breaker controls the flow of electricity to the receptacles in the salon.
Switch this breaker “ON” to supply power to these receptacles. Use the
receptacles as you would the outlets in your home.
NOTE: If this circuit breaker is “ON” but power is not available at any of the
receptacles in this circuit, the circuit’s GFCI receptacle may have tripped. Refer to
“Ground Fault Circuit Interrupters” later in this section for more information.
Refrigerator - Exterior
This breaker controls the flow of electricity to the optional refrigerator at the wet
bar on the bridge. Switch this breaker “ON” to supply power to the refrigerator.
Refer to the OEM information for details on operating the refrigerator.
Refrigerator/Freezer
This breaker controls the flow of electricity to the galley’s refrigerator and freezer.
Switch this breaker “ON” to supply power to the refrigerator and freezer. Refer
to the OEM information for details on operating the refrigerator and freezer.
Reverse Polarity Indicators
These indicators illuminate when the polarity of the shore power source for
the respective line circuit is incorrect. Refer to Section 3 - Shore Power for
information on correcting reverse polarity.
If reverse polarity occurs, immediately switch the respective Shore
circuit breaker group “OFF.”
Shore 1, Shore 2 and Generator
The Shore 1, Shore 2 and both Generator circuit breaker groups allow you to
provide power to the other circuit breakers on the AC Control Center. Each
breaker group consists of two circuit breakers that operate together.
A sliding lockout plate prevents you from switching “ON” both the Shore and
Generator breaker groups for the same line circuit. Slide the lockout plate to the
position necessary to expose the breaker group that you wish to use.
Shore 1 - Switch this breaker group “ON” if you are using a shore power source
to provide electricity to the Line 1 circuit.
Generator (left) - Switch this breaker group “ON” if you are using the
generator to provide electricity to the Line 1 circuit.
Shore 2 - Switch this breaker group “ON” if you are using a shore power source
to provide electricity to the Line 2 circuit.
Generator (right) - Switch this breaker group “ON” if you are using the
generator to provide electricity to the Line 2 circuit.
Spare(s)
These breakers are reserved for aftermarket accessories you install on your boat.