Carver 42 SUPER SPORT, Руководство пользователя

Страница: 75 / 141

4127 • 42 Super Sport 4/06 63
INTERNAL SYSTEMS SECTION 4
Hull Drain
Your boat is equipped with one hull drain. The drain allows water to drain
from the bilges while the boat is in dry storage. The boat and cradle should be
positioned to allow water to flow toward the hull drain. The drain is located in
the transom in the deepest portion of the hull’s “V.”
Make sure the hull drain plug is securely screwed into the hull drain before
launching the boat.
Sanitation System
Your boat’s sanitation system includes the head, waste tank and optional
overboard waste discharge system. When properly used, this system conforms to
all United States antipollution laws.
Toilet
The toilet uses fresh water and vacuum pressure to remove waste from the head.
If you have guests who are unfamiliar with marine sanitation systems, instruct
them on how to properly use the toilet. Refer to the OEM information for
details on operating the toilet.
To operate the vacuum flush system:
1. Turn the Accessory Battery master disconnect switch to the “ON” position.
2. On the Safety Breaker Panel, switch the Vacuum Heads circuit breaker “ON.”
3. Check the holding tank indicator located next to each toilet. If the waste tank
is at least ¾ full, it should be emptied. If not, proceed to step 4.
4. Press the foot pedal at the base of the toilet. This flushes the toilet.
NOTE: Lifting the foot pedal will add additional water without flushing.
It is common for vacuum systems to gradually lose vacuum pressure. When
pressure in the system drops below a predetermined level, the vacuum pump
engages automatically to bring vacuum pressure back to the optimum level.
NOTE: Whenever you don’t want to hear the toilet’s vacuum pump operating, such
as at night, you can temporarily shut it off using the Toilet Run/Sleep switch. Placing
the switch in the “Sleep” position shuts off the toilet’s vacuum pump.
A Tip From Carver!
Coat the threads of the hull drain plug with waterproof grease before you install the
plug into the hull drain fitting. This makes it easier to remove the plug at a later date.