Carver 42 SUPER SPORT, Руководство пользователя

Страница: 52 / 141

40 4127 • 42 Super Sport 4/06
AC ELECTRICAL SYSTEM SECTION 3
7. On the Safety Breaker Panel, switch the Main - One circuit breaker “ON.”
8. On the DC Control Center, switch the System DC Main circuit breaker
“ON,” then switch the four Bilge Blower circuit breakers “ON.”
9. Turn the bilge blowers “ON” using the Bilge Blower switch on the DC
Control Center or at the helm.
Make sure the bilge blowers are operating properly by feeling for air being
blown from the bilge vents. These vents are located on either side of the hull
amidships.
Operate the blowers for at least 4 minutes and until the engine room is free of
any fuel vapor before starting the generator. Continue operating the blowers
while the generator is running.
The generator STOP/START switch is spring activated. Release the
switch from its “START” position as soon as the generator starts. If you
continue to hold the switch in its “START” position after the generator
starts, you may damage the starter.
While you are attempting to start the generator, never hold the STOP/
START switch in the “START” position for more than 10 seconds.
10. Push the spring-loaded generator STOP/START switch, located on the
DC Control Center, to the “START” position and hold it there until the
generator starts. Release the switch when the generator starts.
If the generator does not start within 10 seconds, release the STOP/START
switch, wait 1 minute, then try to start the generator again.
11. When the generator is running smoothly, switch the Generator circuit
breaker group(s) on the AC Control Center “ON.” Power is now available to
the other AC circuit breakers on Line 1 and/or Line 2.
12. To turn the generator “OFF,” push the STOP/START switch to the
“STOP” position. If you do not intend to use the generator again for at
least a few days, turn the generator battery master disconnect switch to
the “OFF” position.
Do not inhale generator exhaust. Generator exhaust contains carbon
monoxide, a poisonous gas. Refer to Section 1 - Carbon Monoxide (CO)
Warnings for more information on engine exhaust and carbon monoxide.