Carver 42 SUPER SPORT, Руководство пользователя

Страница: 58 / 141

46 4127 • 42 Super Sport 4/06
AC ELECTRICAL SYSTEM SECTION 3
Voltmeter
The voltmeter indicates the amount of voltage that is entering the selected line
circuit.
When the boat’s AC electrical system is connected to either a shore power source
or the generator (and the generator is running), the voltmeter should read
between 100 and 130 volts in a 120-volt system or between 210 and 230 volts
in a 220-volt system.
If the voltmeter reads 100 volts or less (205 volts in a 220-volt system), DO
NOT USE THE AC SYSTEM; in this situation, either contact the marina’s
management to identify and correct a shore power problem, or have a qualified
technician service your generator.
If a voltmeter reads zero voltage, it means that no electricity is reaching the
AC Control Center for the selected line circuit. If you are using the generator,
make sure:
• It is operating properly.
• The safety circuit breaker on the generator control panel is “ON.”
If you are using shore power, make sure:
• Your shore power cord is properly attached to both the boat and the shore
power source.
• The appropriate circuit breaker at the shore power source box is “ON.”
• The appropriate AC Main circuit breaker group is “ON.”
• The appropriate Shore (1 or 2) circuit breaker group on the AC Control
Center is “ON.”
If the voltmeter continues to read zero voltage, either have a qualified technician
service your generator or contact the marina’s management to identify and
correct a shore power problem. If the problem appears to be with your boat’s AC
electrical system, have the system inspected by a qualified electrician.
Washer/Dryer
This breaker controls the flow of electricity to the optional clothes washer and
dryer in the utility room. Switch this breaker “ON” to supply power to the
washer and dryer. Refer to the OEM information for details on operating the
washer and dryer.
Water Heater
This breaker controls the flow of electricity to the water heater. The water heater
supplies hot water to your fresh water system. Switch this breaker “ON” to
supply power to the water heater. Refer to the OEM information for details on
operating the water heater.
Do not supply power to the water heater when it is empty. Doing so may
damage the unit’s heating element. Refer to Section 4 - Fresh Water
System to fill, pressurize and prime the fresh water system before
turning on the water heater.