Carver 42 SUPER SPORT, Руководство пользователя

Страница: 79 / 141

4127 • 42 Super Sport 4/06 67
INTERNAL SYSTEMS SECTION 4
Dockside Discharge
With the dockside discharge method, grey water is stored in the grey water tank
until it can be transferred to a dockside pumpout station.
To empty the tank:
1. Locate a dockside pumpout station.
2. Remove the grey water tank deck plate labeled “WASTE” using the removal
tool supplied with your boat. This plate is located in the cockpit on the
aft starboard weatherboard. Refer to Section 9 - Deck Plates for the exact
location of this plate.
3. Attach the pumpout vacuum hose to the “WASTE” deck fitting. Because
the transfer process uses a vacuum action, there must be a secure connection
between the transfer hose and the deck fitting.
4. Activate the pumpout vacuum. The pumpout vacuum transfers the grey water
to the dockside holding station.
5. After all grey water is removed, flush the grey water tank by pouring a few
gallons of fresh water through the “WASTE” deck fitting. Reattach the
vacuum hose to the deck fitting and activate the pumpout vacuum again to
remove the fresh water and any remaining grey water.
6. Replace the “WASTE” deck plate.
Overboard Discharge
NOTE: It is against the law to discharge grey water overboard in some areas of
the United States. It is your responsibility to make sure that you are in compliance
with all applicable Federal, state and local laws when using your boat’s overboard
discharge system. People who discharge grey water overboard in restricted areas are
subject to significant penalties.
With the overboard discharge method, grey water is stored in the grey water
tank until you enter an area where it is legal to pump the grey water directly
overboard. Or, you can still use a dockside pumpout station to empty the grey
water tank.
To empty the tank:
1. Open the overboard discharge seacock. The seacock is located in the engine
room near the grey water holding tank.
2. Turn the Accessory Battery master disconnect switch to the “ON” position.
3. On the Safety Breaker Panel, switch the Main - One circuit breaker “ON.”
4. On the DC Control Center, switch the System DC Main circuit breaker
“ON,” then switch the Grey Water Pump circuit breaker “ON.”
5. Turn the waste pump switch “ON.” The switch is located near overboard
discharge seacock. This activates the waste pump, which pumps the grey
water overboard.
When the grey water tank is empty, turn the waste pump “OFF.”
Operating the waste pump when the grey water tank is empty can
damage the pump.
Open Closed