Carver 42 SUPER SPORT, Руководство пользователя

Страница: 49 / 141

4127 • 42 Super Sport 4/06 37
AC ELECTRICAL SYSTEM SECTION 3
11. Secure the nonmetallic threaded locking ring that locks each cord to the
shore power source outlet. This prevents the cord(s) from being accidentally
disconnected and from arcing due to a gap between the cord plug and the
outlet.
12. Switch the circuit breaker that is installed in the shore power source
box “ON.”
13. Switch the AC Main circuit breaker group(s) “ON.”
14. There is a Reverse Polarity indicator on the AC Control Center for Shore #1
and Shore #2. If either or both of these indicators illuminate, immediately
switch the respective AC Main circuit breaker group(s) “OFF.”
If you are in Germany or Italy, disconnect the shore power cord from the
shore power source outlet, rotate the cord’s plug 180 degrees, then plug
the cord into the outlet again. Repeat steps 11 through 13. If the Reverse
Polarity indicator(s) illuminates again, disconnect the affected shore power
cord. Notify marina management of the reverse polarity problem and use a
different shore power source box.
If you are not in Germany or Italy, disconnect the shore power cord. Notify
marina management of the reverse polarity problem and use a different shore
power source box.
If the Power Available indicator(s) illuminates, it is safe to proceed to step 15.
15. On the AC Control Center, switch the Shore 1 and/or Shore 2 circuit breaker
group(s) “ON.” Power is now available to the other AC circuit breakers on
Line 1 and/or Line 2, respectively.
16. Monitor the voltmeter(s) and ammeter(s) on the AC Control Center while
your boat is connected to the shore power source. The operation of the
voltmeter and ammeter is described later in this section.
Only people who are trained and experienced in working with
electricity should service your boat’s high voltage AC electrical system.
Inexperienced or untrained people may be killed or seriously injured by
incorrectly servicing the AC electrical system.
Always disconnect the boat from the shore power source, shut off the
generator and disable the inverter before attempting to service the AC
electrical system.