Carl Valentin DYNACODE, Руководство по эксплуатации

Страница: 61 / 116

Dynacode series Function menu
10.15 Operating manual 61
7.13 Interface
Press key to access the function menu.
Press key as long as you arrive at the 'Interface' menu.
Press key to select the menu.
COM1:
0 - serial interface Off.
1 - serial interface On.
2 - serial Interface On, no error message occurs in case of a
transmission error.
Baud rate:
Indication of bits which are transferred per second.
Following values are possible: 1200, 2400, 4800, 9600, 19200, 38400
and 115200.
P = Parity:
N - No parity; E - Even; O - Odd
Please observe that the settings correspond to those of the direct print
module.
D = Data bits
Setting of data bits.
Value range: 7 or 8 Bits.
S = Stop bits
Indication of stop bits between bytes.
Value range: 1 or 2 stop bits.
Press key
to arrive at the next menu item.
SOH:
Start of data transfer block Hex format 01
ETB:
End of data transfer block Hex formal 17
Two different start / en signs can be set. The settings are normally
SOH = 01 HEX and ETB = 17 HEX. Several host computers cannot
process these signs and therefore SOH = 5E HEX and ETB = 5F
cannot be set.
Press key
to arrive at the next menu item.
Data memory:
Standard:
After starting a print order the direct print module buffer
receives data as long as it is filled.
Advanced:
During a current print order data is received and
processed.
Off:
After starting a print order no more data is received.
Press key to arrive at the next menu item.
Porttest:
Check whether the data are transferred via the interface.
Press the and keys to select standard (on). Press the
key
and the data sent via any port (COM1, LPT, USB, TCP/IP) is printed.