Carl Valentin DYNACODE, Руководство по эксплуатации

Страница: 76 / 116

Maintenance and cleaning Dynacode series
76 Operating manual 10.15
Figure 24

Remove ribbon cassette.

Move printhead unit in an appropriate service position.

Press printhead support (A) slightly downwards until an Allen key
(2.5) can be inserted in the screws (B).

Remove screws (B) and afterwards the printhead (C).

Remove rear-mounted connection assembly from printhead

Insert connection assembly to the new printhead.

Position printhead in printhead support (A), so the engaging
pieces catch in the appropriate holes in the printhead support (A).

Hold printhead holder (A) with a finger slightly on the pressure roll
and check the correct position of printhead (C).

Screw in screw (B) and tighten it with an Allen key.

Insert again ribbon cassette (see chapter 5 on page 37).

Enter the resistance value of the new printhead in the 'Service
Functions/Heater resistance'. The value is indicated on the type
plate of printhead.

Start a test print to check printhead position.
Removing the
printhead
Installing the printhead