Canon NP6085, Руководство по обслуживанию

Страница: 394 / 502

6) Hook the charging wire on the charging wire
positioner at the rear; then, hook the charging
wire tension spring on the charging wire as
shown, and twist it.
Figure 4-524
7) Cut the excess end of the charging wire with a
nipper.
8) Pick the end of the charging wire tension
spring with tweezers, and hook it on the charg-
ing electrode.
In the case of the pre-transfer charging assem-
bly, hook the loop of the charging wire on the
charging electrode, and hook the spring on the
pin at the front.
Figure 4-525
Check to make sure of the following:
• The charging wire is free of bends or
twists and its gold plating has not peeled.
• The charging wire is in the V-shaped
charging wire positioning groove.
Figure 4-526 Primary Charging Wire
9) Install the cushion to the front of the charging
assembly. (This does not apply to the primary
charging assembly.)
10)Install the shielding plate (left, right).
For other charging assemblies, install the
lids (2 pcs.).
11)Install the wire cleaner. (At this time, make
sure that the orientation of the wire cleaner is
correct.)
12)Wipe the charging wire with lint-free paper
moistened with alcohol.
• Do not clean the wires with a cloth coat-
ed with metal powder.
• Do not clean the wires with a moist cloth.
Dry wipe the wires with lint-free paper;
then, use alcohol. Check to make sure
that the part is completely dry before
installing it to the copier.
4. Routing the Grid Wire of the Primary Charging
Assembly
1) Loosen the two screws at the front used to
keep the left and the right shielding plates in
place.
2) Loosen the four screws used to keep the motor
unit in place at the front.
Figure 4-527
4. MECHANICAL SYSTEM
COPYRIGHT © 1996 CANON INC. CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
4-73
Caution:
(correct)
(wrong)
(correct) (wrong)
Grid side
Caution:
Caution:
Screws
Screws