Canon NP6085, Руководство по обслуживанию

Страница: 22 / 502

B. Basic Operation
1) Turn ON the power switch.
q
The Wait indicator turns ON in green.
w
Normally, the wait time is 6 min (at ambient
temperature of 20 ÞC).
Reference:
Auto start mode may be selected during
the wait period. (See p. 1-15.)
2) Open the RDF, place the original face down,
and close the RDF. Or, set the original in the
RDF.
3) Select the appropriate reproduction ratio.
q
Reduce, Direct, Enlarge Key
Press it to make a default size copy from a
default size original.
w
Zoom Key
Set the appropriate reproduction ratio
between 50% and 200% in 1% increments.
e
Fit Image Key
Press it to make a copy reduced to 93%
(may be changed between 90% and 99% in
1% increments).
4) To select a specific copy paper size, select the
appropriate tray by pressing the Paper Select
key.
q
Place paper of the appropriate size on the
multifeeder as necessary.
5) Set the appropriate copy density.
q
To use AE (automatic adjustment), press
the AE key and check that the notation has
reversed.
w
To make a darker copy manually, press the
Copy Density key
so that the lamp
moves to the right; to make a lighter copy,
on the other hand, press the
key so
that the lamp moves to the left.
Figure 1-6
Use manual mode if you are copying origi-
nals with a high transparency (e.g., trans-
parencies).
6) Enter the appropriate copy count (1 to 999) on
the numeric keypad, and check the copy count
indicator.
q
If you cannot enter a number on the numer-
ic keypad or if you made a mistake, press
the Clear key and enter the correct number
once again.
7) Press the Copy Start key.
q
If you placed an original on the RDF’s orig-
inal tray, the original will be picked up auto-
matically and copying will start.
w
As many copies as set will be made.
e
You may perform the following between
when copying starts and when as many
copies as you have set are made:
• Stopping Copying Operation
To stop continuous copying operation,
press the Stop key or the Reset key; the
operation will stop after completing the
on-going copying run.
• Switching from AE Mode to Manual
Density Adjustment Mode
You may switch from AE mode to manual
density adjustment mode during continu-
ous copying.
If the copy is too dark or too light in AE
mode, press the Copy Density key as
necessary while referring to the density
of the copy made in AE mode until the
desired density is obtained.
You cannot, however, switch from manual
density adjustment mode to AE mode
during continuous copying.
• Interrupting for a Different Copy
See p. 1-22.
Keys other than the Stop, Reset, Interrupt,
and Copy Density keys are not accepted
during continuous copying.
Light
Dark
1. GENERAL INTRODUCTION
COPYRIGHT © 1996 CANON INC. CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
1-14
Light Dark
Note:
Note: