Canon imageRUNNER ADVANCE 6075 Series, Руководство по обслуживанию

Страница: 1026 / 1406

9
9
9-29
9-29
Installation > Installation > Image Position Adjustment > Leading Edge Margin Adjustment (2nd side)
Installation > Installation > Image Position Adjustment > Leading Edge Margin Adjustment (2nd side)
■
Leading Edge Margin Adjustment (1st side)
NOTE:
By executing the leading edge margin adjustment for the Cassette 3, the adjustment is
applied to all source of paper.
Execute printing from the Cassette 3, and check that the leading edge margin is within L1 2.5
+/- 0.5mm.
If it is not within the range, execute adjustment by following the procedure below.
Feeding direction
of paper
image
L1
1) Adjust the image position in service mode.
• COPIER > ADJUST > FEED-ADJ > REGIST
As the value is incremented by 1, the leading edge margin is decreased by 0.1mm.
2) Execute duplex printing from the Cassette 3, and check that the leading edge margin is
within 2.5 +/- 0.5mm.
3) When the setting value was changed in step 1), write down the new numerical value in the
service label.
4) Exit from the service mode.
F-9-59
■
Leading Edge Margin Adjustment (2nd side)
NOTE:
By executing the leading edge margin adjustment for the Cassette 3, the adjustment is
applied to all source of paper.
Execute duplex printing from the Cassette 3, and check that the leading edge margin on the
2nd side is within L1=2.5 +/- 0.5mm.
If it is not within the range, execute adjustment by following the procedure below.
Feeding direction
of paper
image
L1
1) Adjust the image position in service mode.
• COPIER > ADJUST > FEED-ADJ > REG-DUP1
As the value is incremented by 1, the leading edge margin is decreased by 0.1mm.
2) Execute duplex printing from the Cassette 3, and check that the leading edge margin is
within 2.5 +/- 0.5mm.
3) When the setting value was changed in step 1), write down the new numerical value in the
service label.
4) Exit from the service mode.
F-9-60