Canon imageRUNNER ADVANCE 500i, Список кодов ошибок

Страница: 4 / 30

4
* If paper is being fed, the error occurs
after the paper has been delivered. (M3).
3. Replace the DC Controller PCB
(PCB1).
E014-
0001
Fixing Motor (M1) rotation error
The lock signal was not detected for 2.0
seconds while detecting the signal every
100msec since starting the drive of the
motor.
1. Check the connector connection
between the Fixing Motor (M1) and
the DC Controller PCB (PCB1).
2. Replace the Fixing Motor (M1).
3. Replace the DC Controller PCB
(PCB1).
E014-
0002
Fixing Motor (M1) rotation error
The lock signal was not detected 5 times
in a row for 500msec while detecting the
signal every 100msec during driving
(after the lock signal detection).
1. Check the connector connection
between the Fixing Motor (M1) and
the DC Controller PCB (PCB1).
2. Replace the Fixing Motor (M1).
3. Replace the DC Controller PCB
(PCB1).
E014-
0003
Fixing Motor (M1) pressure release error
The pressure release of the Fixing
Assembly was not detected for 3.0
seconds during the pressure release
drive.
1. Check the connector connection
between the Fixing Pressure Release
Sensor (PS18) or the Fixing Motor
(M1) and the DC Controller PCB
(PCB1).
2. Replace the Fixing Pressure
Release Sensor (PS18).
3. Replace the Fixing Motor (M1).
4. Replace the DC Controller PCB
(PCB1).
E014-
0004
Fixing Motor (M1) pressurization error
The pressurization of the Fixing
Assembly was not detected for 3.0
seconds during the pressurization drive.
1. Check the connector connection
between the Fixing Pressure Release
Sensor (PS18) or the Fixing Motor
(M1) and the DC Controller PCB
(PCB1).
2. Replace the Fixing Pressure
Release Sensor (PS18).
3. Replace the Fixing Motor (M1).
4. Replace the DC Controller PCB
(PCB1).
E020-
0000
Detection of the toner clog between the
Hopper Unit and the Developing
Assembly
When the Developing Assembly Toner
Sensor (TS2) detected “toner-absent”
and the Hopper Toner Sensor (TS1)
detected “toner-present”, the Developing
Assembly Toner Sensor (TS2) did not
detect “toner-present” though the Hopper 1. Check the rotation of the Hopper
Motor Gear. (If it is rotating, the
sensor may not be detecting
correctly. In that case, perform the
following to supply toner to the
Developing Assembly: COPIER >
FUNCTION > INSTALL > TONER-S
in the Service Mode.)
2. Replace the Developing Assembly.