Candela AlexTriVantage, Руководство оператора

Страница: 96 / 116

6-6 Confidential 8501-00-1800, Revision 05
Candela Corporation AlexTriVantage Laser System
Ambient Temperature
Maintain the temperature in the laser room between 50° and 80°F (10° and 27°C).
Avoid placing the laser system near heating outlets or other openings that might be the
source of air currents that could cause uneven cooling in the laser system.
The laser system must be stored at a temperature between 40° and 110° F (4.5° and
43°C).
Relocation
Care should always be taken when moving the AlexTriVantage Laser System. Before moving
the laser, disconnect the Footswitch tubing from the connector located on the rear panel of
the laser and the Delivery System from the front of the laser (place the Delivery System into
its original box for transportation if necessary). A handle located on the rear panel allows
easy movement of the system, but take special care when maneuvering over thresholds,
elevator doors, ramps and other uneven or sloping floor surfaces. A severe physical shock
could cause the alignment of the laser head or the optical fiber to be disturbed resulting in
personal injury or physical damage.
If it becomes necessary to relocate the laser, contact Candela Technical Support or your
distributor for details. Failure to do so may result in personal injuries or damage to the system
and may void any warranty.
Mobile Use
The AlexTriVantage Laser System is not designed for mobile use.
Transport and Storage
For transport and storage of the AlexTriVantage Laser system, the temperature must be kept
between 40° and 110° F (5° and 43°C) and humidity between 20% to 80% (non-condensing).
Ambient atmospheric pressure is suitable with no restrictions.
Internal Cooling Water Requirements
Distilled water: 1.8 liters, provided by the customer (readily available at
hospitals, where it is used for sterile water).
Using water that is not deionized will result in poor flashlamp performance, and may result in
permanent flashlamp damage.
Warning: Do not use the Fiber Pole to lift or move the laser system. It was not
designed to sustain the weight of the laser when it is being moved.
Warning: Do not expose to temperatures below 5°C (40° F) or damage may
occur. If the laser is exposed to temperatures below 5°C, contact Candela
Technical Support prior to use.