Candela AlexTriVantage, Руководство оператора

Страница: 94 / 116

6-4 Confidential 8501-00-1800, Revision 05
Candela Corporation AlexTriVantage Laser System
Electrical Requirements
In the US and Asia Pacific, a NEMA L6-30R receptacle, or equivalent, is required. For
Europe, an IEC 309, Blue, 32 Amp receptacle or equivalent is required.
The power cord is a approximately 12-foot power cord with a locking NEMA L6-30P plug for
power connection in the United States. The installation site required a mating NEMA L6-30R
power receptacle located within 10 feet of the intended laser system location.
The power receptacle must be within 10 feet (approximately 3 meters) of the intended laser
system location, and must be earth-grounded. The safety ground wire of the power system
(green or green with a yellow stripe) is an acceptable ground for the laser system, provided
that it is terminated only to an earth ground stake or dedicated ground grid. Poor grounding
can interfere with the operation of the laser system.
The power receptacle for the laser system must meet the following requirements:
Electrical Requirements:
USA 208 V~
Europe 230 V~
Asia Pacific 200 V~
Maximum line voltage variation ± 10%) 50/60 Hz, single phase,
Rated Current 26 A peak at 230 V~
16 A RMS at 230 V~
Electrical Service
For CE Countries: 20 A minimum service supported by a 100 A mains **
For non-CE Countries: 20 A service minimum
The input power line should be free of transients (spikes, sags and/or surges). A dedicated
branch circuit is recommended.
Operation of the AlexTriVantage Laser on a power line that is not consistently within the
specification may cause damage to the system and may void the warranty.
Warning: The power plug must be installed by a qualified person, in
accordance with IEC requirements and the appropriate national electrical
code.
Note: ** The Alex TriVantage is subject to a conditional connection to the public mains
to reduce the effects of Flicker emissions. For details on Flicker and line impedance
requirements, please refer to the EMC Guidance document (8501-00-1822) provided in
your accessory kit.