Rev 1.0
64
9.5.5
Sensor init
Analogous to the setup on your data display, the
sensor init
settings can also be made directly via the
DSS
.
Figure 72: Sensor init
For most applications, it is sufficient to set
RPM
to the sensor speed , speed to the
sensor
speed and
gear
to the
sensor gear. For automatic vehicles,
Gear Mode
can still be set to gear. The others are
to be set to NA. The explanation of the functions can be found in the figure above.
9.5.6
IO pins
This menu item cannot be accessed directly via
the setup of the data display. In this menu item, the
pins for the
functions PageSwitch
,
Brightness
and
Frequency In
can be assigned and activated.
Figure 73: IO pins
Via
PageSwitch
, the side of the data display can be switched to the next by closing to ground on one
of the pins selectable in the drop-down menu. Here it may be necessary to install an external pullup
resistor (10K ohm).
The same applies to the
Brightness
Pin, so the display can be dimmed by an external switch.
The
Frequency In
is used to feed 0-5 V square wave signals (e.g., wheel or charger speed) into your
data display. For example, see our instructions for the FlexFuel Sensor (ethanol).
9.5.7
Can Transmit
In this menu item you can configure the start state (
Default status
), the behavior (
Momentary
=
button, otherwise switch) as well as a pop-up window (
Inform
) for your can switches.
Содержание MFD28 Gen2
Страница 1: ...MFD28 32 Gen2 Manual...
