CAN CHECKED MFD28 Gen2, Руководство пользователя

Страница: 13 / 75

Rev 1.0
13
5.2.1 TRI/TRX File
Under the submenu item TRI/TRX File you can select the TRI/TRX File you need from a list or scan
your engine data (UDS only) if your engine code letter (MKB) is not yet in the list to start a service
request under
info@canchecked.de . Depending on which firmware is installed on your display, you
may only find TRI/TRX files that start with S-XXX, T-XXX, U-XXX or O-XXX. If you want to see other
TRI/TRX files you have to flash the appropriate firmware. More information can be found in chapter
6.2
5.2.2 Can Speed
In this sub-item you can set the speed of your Can bus by clicking on the number. Our data display
currently supports the following speeds of 125, 250, 500 and 1000 kbit/s.
5.2.3 Can Term
This slider can be used to activate or deactivate a 120 Ohm Can Bus terminator.
5.2.4 Can Filter
By clicking on this submenu, various can filters (OBD or vehicle-specific) can be activated or
deactivated.
5.2.5 Protocol
For active logs , there is a slider in the menu to turn the log on or off. Disabling the protocol may be
necessary, for example, to access the ECUs via a diagnostic tool. For later operation of the data
display, however, the
protocol must then be reactivated.
5.2.6 Can Switch
Your Gen2 data display can not only receive Can Bus data, but also send it. These can be:
•
Touch Button Status (on/off, e.g., to activate Launch Control, ALS or a fan)
•
Forwarding of the 4 analog inputs or the digital inputs to the control unit
•
Converting Can Bus messages to other addresses
In the Can Switch submenu, a selection of Can Switches can be made by clicking on the setting. The
following settings are currently offered:
•
Off (no Can Switches activated)
•
Custom (Can switches can be configured via DSS 9.5.7
•
EMU v3
•
LinkECU
•
MaxxECU
•
Motec
With the preconfigured Can Switches , the data display emulates the manufacturer specific Can
Switch boards (Ecumaster) or ready-made messages, which can be found in our specific instructions
for the ECUs.
5.2.7 Timeout
In the Timeout submenu, the length of the timeout until the next data query for logs can be set by
tapping on the number. By default, this is two milliseconds. The time can be set in increments from
two to 20.
5.3 Sensor Init
In the Sensor Init submenu, individual sensors are assigned to essential functions of the data display .