Cambium Networks PTP 450 Series, Руководство по настройке

Страница: 177 / 649

Chapter 1: Configuration Configuring radio parameters
Page
1-149
The time (in minutes) for a subscriber to rescan (if this AP is not configured
with the SM‘s primary color code). This timer will only fire once – if the
Subscriber Color Code Wait Period for Idle timer is configured with a
nonzero value and the Subscriber Color Code Rescan expires, the
Subscriber Color Code Wait Period for Idle is started. If the Subscriber
Color Code Wait Period for Idle timer is configured with a zero value and
the Subscriber Color Code Rescan timer expires, the SM will immediately
go into rescan mode
Subscriber Color
Code Wait Period for
Idle The time (in minutes) for a subscriber to rescan while idle (if this AP is not
configured with the SM’s primary color code). This timer will fire periodic
events. The fired event determines if any RF unicast traffic (either inbound
or outbound) has occurred since the last event. If the results of the event
determine that no RF unicast traffic has occurred (SM is idle), then the
subscriber will rescan.
Installation Color
Code With this feature enabled on the AP and SM, operators may install and
remotely configure SMs without having to configure matching color codes
between the modules. While the SM is accessible for configuration from
above the AP (for remote provisioning) and below the SM (for local site
provisioning), no user data is passed over the radio link. When using the
Installation Color Code feature, ensure that the SM is configured with the
factory default Color Code configuration (Color Code 1 is “0”, Color Code 2-
10 set to “0” and “Disable”). The status of the Installation Color Code can be
viewed on the AP Eval web GUI page, and when the SM is registered using
the Installation Color Code the message “SM is registered via ICC – Bridging
Disabled!” is displayed in red on every SM GUI page. The Installation Color
Code parameter is configurable without a radio reboot for both the AP and
SM. If a SM is registered via Installation Color Code and the feature is then
disabled, operators will need to reboot the SM or force it to reregister (i.e.
using Rescan APs functionality on the AP Eval page).
Sector ID This pull-down menu helps in configuring the Sector ID at a configurable
value from 0 to 15.
MIMO Rate Adapt
Algorithm This pull-down menu helps in configuring the Rate Adapt Algorithm to
MIMO-A/B, MIMO-B only, or MIMO-A only.
Downlink Maximum
Modulation Rate This pull-down menu helps in configuring the Downlink Maximum Modulation
Rate at a configurable rate of 1X, 2X, 3X, 4X, 6X, or 8X. The default value is
“8X”. The Rate Adapt Algorithm does not allow the modulation to go
beyond this limit.
Uplink Maximum
Modulation Rate This pull-down menu helps in configuring the Uplink Maximum Modulation
Rate at a configurable rate of 1X, 2X, 3X, 4X, 6X, or 8X. The default value is
“8X”. The Rate Adapt Algorithm does not allow the modulation to go
beyond this limit.
Max Range Enter the number of miles or kilometers for the furthest distance from which
a SM is allowed to register to this AP. Do not set the distance to any greater
number of miles. A greater distance