Cambium Networks PTP 450 Series, Руководство по настройке

Страница: 297 / 649

Chapter 1: Configuration Configuring Radio via config file
Page
1-269
2 Click on “Browse” button under “Upload and Apply Configuration File” tab and select the
configuration file from disk.
3 Click “Upload” followed by “Apply Configuration File” button click.
4 The “Status of Configuration File” section will show the results of the upload.
5 Review it to make sure there are no errors. Then click on “Reboot” to reboot with the
imported configuration
The special headers for config file is explained below:
Procedure 19 Special Headers for configuration file
1 A “configFileParameters” section can be added to the header to control the behavior of the
device when importing configuration.
2 The “setToDefaults” when set to “true” tell the device to reset to factory default
configuration and apply the configuration in the file on top of that. So any attribute not in
the configuration file will be set to its factory default value. By default, the configuration in
the file is merged with the existing configuration on the device.
The “rebootIfRequired” flag when set to “true” tell the device to reboot automatically if
needed to apply the configuration change. By default, the device will not reboot
automatically.
{
“cfgFileString”: “Canopy configuration file”,
“cfgFileVersion”: “1.0”,
“configFileParameters”: {
“setToDefaults”:true,
“rebootIfRequired”:true,
}
}